All guides

Redrock guide: phases, timing and the math that repeats

How Redrock (Red Rock Study) works, how to split the 35 minutes between the study and the 6 mini cases, and the most common calculation traps.

Updated October 25, 2026. 8-minute read.

Practice Redrock for free
Video walkthrough. The full written guide is below.

Redrock is the data analysis game in the Solve: 35 minutes, simple calculations with percentages and rates, and the key is to filter data with good judgment without losing your pace.

What it is and how it is scored

Redrock (or the Red Rock Study) is usually the first game in the Solve and the one most like a case: you read a research scenario (for example, about a wolf population), pull out data, make calculations and deliver a report. It lasts about 35 minutes with a single clock, with no separate timers for each part.

The math is basic: percentages, growth rates, ratios and averages. The hard part is the pace, the interface and not mixing up units or time periods.

According to the guides, two things are assessed:

  • Result: how correct your answers and the numbers in your report are.
  • Process: how you worked. Your clicks and drags are recorded, and your calculations are logged in the in-game calculator.

The parts of the game

Part 1: the study, in 3 consecutive phases

  1. Investigation. You read the objective, several paragraphs of background (often with proposals or scenarios to compare) and exhibits with tables and charts, and drag the useful data into a research journal. Much of the text contains data you won’t need. Each data point carries a unit, a time period and a label.
  2. Analysis. You answer calculation questions using the saved data and the in-game calculator, usually three and sometimes with several boxes each (for example, the value for each group under a proposal). You can drag data from the journal into the calculator.
  3. Report. It has three steps: you fill in the blanks of a report (numbers and choices such as “increased / decreased”), choose the type of chart that fits your message (bars to compare categories, lines for trends over time, pie for parts of a whole) and then build it by entering its values. According to candidate reports, the chosen chart can’t be changed and once you enter the report you can’t go back to the study.

Part 2: six mini cases

Each one is a short quantitative question with its own chart or table. The guides describe types that keep coming up:

  • Choosing which data is relevant among several distracting data points.
  • Calculating what percentage of the total a part represents.
  • Ranking by rate (the highest proportion), not by quantity.
  • Comparing the mean and the median.
  • Probability, often using the complement (1 minus the probability of the opposite).

Strategy by phase

The routine the guides repeat is: objective, filter, calculate.

  • Investigation: read the objective first and only then look at the data. You can’t see the questions yet, but the objective tells you what will be calculated: for each thing it asks for, think about what calculation it implies and what data that needs. Save those, with unit and period. If you’re unsure about one, save it: an extra data point costs less than being left without one you needed, because you can’t always go back. What you need to avoid is saving everything.
  • Analysis: build the formula in your head before you type. Mistakes usually come from mixing up units or periods, not from the arithmetic. Reuse saved results instead of retyping rounded numbers.
  • Report: the chart is chosen for the message you want to show, not for the data you have. Check that the units match what the text asks for.
  • Mini cases: finish all 6 rather than perfecting one. If one is eating up your clock, estimate and move on.
  • Order: work in a structured way, without jumping back and forth between phases, because the process counts too.

Do you lose points for saving extra data?

McKinsey doesn’t say. Most guides treat it as a matter of order and time: a journal full of irrelevant data slows you down in the analysis. In a PrepLounge forum thread, two coaches also state that saving a lot of irrelevant data does lower your process score. With that information, the reasonable approach is to be selective without obsessing over it: save everything the objective needs and, at most, one or two doubtful data points.

Time management

The 35 minutes are a single clock. If the study drags on, the mini cases run out of time, which is the most common mistake. A reference split:

Part Minutes
Investigation 6–8
Analysis 8–10
Report 4–6
6 mini cases 11–13 (about 2 per case)

Rule of thumb: if a question goes past about 90 seconds, estimate and move on.

The math that keeps coming up

It isn’t hard, but it has well-known traps:

Topic Trap How to avoid it
Percentage growth Saying that going from 400 to 520 is +120% Divide the change by the starting value: 120 / 400 = +30%
Percent vs. points Calling a rise from 10% to 15% “+5%” It is 5 percentage points, or +50% in relative terms
Ranking by rate Choosing the one with the largest quantity Compare proportions, not totals
Weighted average Averaging the averages of each region Add up all the numerators and divide by the sum of the denominators
Units and periods Mixing months with years, or thousands with millions Check the unit and period of each data point before calculating
Mean vs. median Using the wrong one Read carefully what the question asks for
Probability Calculating it the long way Sometimes it is simpler with 1 minus the complement

Common mistakes

  1. Collecting too much data in the investigation and ending up with a journal that is no use.
  2. Rushing the investigation: if you’re missing a data point later, you can’t always go back.
  3. Mixing up units and periods, the most common source of errors in the analysis.
  4. Retyping rounded numbers instead of reusing the saved ones, carrying the error forward.
  5. Choosing the chart by the data and not by the message.
  6. Getting stuck on one mini case and leaving the rest without time.
  7. Treating the study and the mini cases as separate clocks. There is only one.

How to practice with the simulator

  1. Play one game in learning mode to get to know the interface: journal, calculator and report.
  2. Play full 35-minute games in test mode. You learn the pace with the real clock.
  3. Train percentages, ratios and growth rates until they are automatic.
  4. When you finish, review where you lost time or points, not just the result.

To see all of this in action, Redrock solved walks through a full game, with every calculation and its traps.

Sources

McKinsey doesn’t publish the scoring or the ideal timings, so the figures come from prep sites (several sell courses) and differ from one another.